BC90SL – 90° Wall Mount Clamp with Small Leg and Beveled Profile 2” x 2” – Compare to SGC037

Description

• Glass shower clamp with beveled edges
• For 3/8” – 1/2” glass
• For use with tempered or tempered/laminated glass
• Solid brass
• Attaches glass panel to adjoining surface at 90°
• A 3/4” hole must be drilled into the glass for installation
• Compare to SGC037

Other Details

• Edge: Beveled profile
• Compare to: SGC037

Technical Specifications

• Leave a 1/8” - 3/16” gap between the glass and the adjoining surface and seal this with silicone.
• Only tempered or laminated tempered glass may be used.
• Avoid using power tools during installation as these may damage the finish.
• A single set of gaskets is provided with the clamp and is intended for use with either 3/8” or 1/2” glass.

Product Details

This Glass Simple clamp has a small leg and is used to connect a fixed glass panel to an adjacent wall, floor, or ceiling at 90 degrees. The beveled profile coordinates with many of our other products.

Cleaning Your Glass Simple Hardware

• Dry hardware after use to minimize water spots and other discoloration.
• Avoid harsh or abrasive cleaning agents, scrub brushes, etc. as these will damage the finish.
• Use a mild mixture of gentle liquid soap and water and test on an inconspicuous part of the hardware first.
• After washing, thoroughly rinse with clean warm water and buff dry.

⚠️ WARNING: This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information, go to www.P65Warnings.ca.gov