Description

Wall mount hinge with full back plate. Self-centering, (90 degree factory set). The pin can be reversed to 85 degrees, thus allowing for a 5 degree tighter close.
For 3/8”-1/2” (10mm-12mm) tempered glass
Solid brass
Swings 90 degrees both ways
Compare to Geneva GEN037, Designer HGTWFP

Other Details

Edge: Square profile

Technical Specifications

If using 2 hinges, maximum door weight is 80 lbs and maximum door width is 28” (711 mm).
If using 3 hinges, maximum door weight is 120 lbs, and maximum door width is 32” (813 mm).
DO NOT exceed the maximum door weight OR door width for the number of hinges you are using.
Use tempered or tempered laminated glass only. Do not use power equipment to install these hinges as it could damage the finish.
Gasket Specifications: A single set of gaskets is provided with the hinge and is intended for use with either 3/8” or 1/2" glass.

Product Details

The Genesis series hinge offers appealing features. It is a wall mount hinge with full back plate made of solid brass and available in various popular finishes. The 90 degree factory setting of the pivot pin is right for standard door closure. Purchaser can adjust the pivot pin for 5 more degrees of closure if the door needs to close with more pressure against the jamb.

Cleaning Your Glass Simple Hardware

Dry hardware after use to minimize water spots and other discoloration.
Avoid harsh or abrasive cleaning agents, scrub brushes, etc. as these will damage the finish.
Use a mild mixture of gentle liquid soap and water and test on an inconspicuous part of the hardware first.
After washing, thoroughly rinse with clean warm water and buff dry.

Hinge Care

Glass Simple hinges arrive pre-greased for quiet operation.
In the event of a hinge squeaking, add a several drops of multi-purpose oil around the nylon washer.
If the hinge is taken apart, the interior components should be lubricated with a little bit of white lithium grease.
Avoid spray-on lubricants.

Compare to:

GEN037, HGTWFP