VER5F – GLASS SIMPLE VERONA SQUARE PROFILE WALL MOUNT SHOWER DOOR HINGE WITH FULL BACK PLATE & FACTORY SET TO 5 DEGREE POSITIVE CLOSE - Compare to V1E537, HMGTW5FP

Description

• Self-centering wall mount hinge with full back plate
• For 1/2” (12mm) tempered glass
• 5 degree offset
• Solid brass
• Replacement screws available
• Compatible with hinge limit plates HLP25 and HLP40
• Compare to Vienna V1E537, Majestic HMGTW5FP, Venice VENF5,

Other Details

• Edge: Square profile
• Compare to: Vienna V1E537, Majestic HMGTW5FP, Venice VENF5

Technical Specifications.

• Maximum door capacity for 1/2" (12 mm) glass is approximately 6.4 lb/ft².
• If using 2 hinges, maximum door weight is 110 lbs and maximum door width is 36” (914 mm).
• If using 3 hinges, maximum door weight is 140 lbs, and maximum door width is 36” (914 mm).
• DO NOT exceed the maximum door weight OR door width for the number of hinges you are using.
• Only monolithic tempered glass may be used.
• Avoid using power tools during hinge installation as these may damage the finish.
• One thin gasket on each side is needed for 1/2" (12 mm) glass.

Product Details 

The Verona series hinge offers appealing features. It is a sold brass wall mount hinge with HD S/S back plate, available in various popular finishes. The 90 degree factory setting of the pivot pin is right for standard door closure. Purchaser can adjust the pivot pin for 5 more degrees of closure if the door needs to close with more pressure against the jamb.

Cleaning Your Glass Simple Hardware 

• Dry hardware after use to minimize water spots and other discoloration.
• Avoid harsh or abrasive cleaning agents, scrub brushes, etc. as these will damage the finish.
• Use a mild mixture of gentle liquid soap and water and test on an inconspicuous part of the hardware first.
• After washing, thoroughly rinse with clean warm water and buff dry.

Hinge Care 

• Glass Simple hinges arrive pre-greased for quiet operation.
• In the event of a hinge squeaking, add a several drops of mult-purpose oil around the nylon washer.
• If the hinge is taken apart, the interior components should be lubricated with a little bit of white lithium grease.
• Avoid spray-on lubricants.