- SKU:
- GEN5F
GEN5F - GLASS SIMPLE GENESIS SQUARE PROFILE WALL MOUNT SHOWER DOOR HINGE WITH FULL BACK PLATE & FACTORY SET 5 DEGREE POSITIVE CLOSE - Compare to GEN537, HGTW5FP
Brand : Glass Simple
- Compare to:
- GEN537, HGTW5FP
Description
- Wall mount hinge with full back plate. Pre-Set to 5 Degree aditional close, (85 Degree factory set). The Pin can be reversed to 90 Degrees, thus allowing the door to close to a self center position.
- For 3/8”-1/2” (10mm-12mm) tempered glass
- 5 degree offset
- Solid brass
- Swings 90 degrees both ways
- Compare to Geneva GEN537, Designer HGTW5FP
Other Details
- Edge: Square profile
Technical Specifications
- If using 2 hinges, maximum door weight is 80 lbs and maximum door width is 28” (711 mm).
- If using 3 hinges, maximum door weight is 120 lbs, and maximum door width is 32” (813 mm).
- DO NOT exceed the maximum door weight OR door width for the number of hinges you are using.
- Use tempered or tempered laminated glass only. Do not use power equipment to install these hinges as it could damage the finish.
- Avoid using power tools during hinge installation as these may damage the finish.
- Gasket Specifications: A single set of gaskets is provided with the hinge and is intended for use with either 3/8” or 1/2" glass.
Product Details
The Genesis series hinge offers appealing features. It is a wall mount hinge with full back plate made of solid brass and available in various popular finishes. The hinge comes with the pin set at 85 degrees for 5 degrees of extra pressure against the jamb. The pin can be adjusted for standard 90 degree door closure if desired.
Cleaning Your Glass Simple Hardware
- Dry hardware after use to minimize water spots and other discoloration.
- Avoid harsh or abrasive cleaning agents, scrub brushes, etc. as these will damage the finish.
- Use a mild mixture of gentle liquid soap and water and test on an inconspicuous part of the hardware first.
- After washing, thoroughly rinse with clean warm water and buff dry.
Hinge Care
- Glass Simple hinges arrive pre-greased for quiet operation.
- In the event of a hinge squeaking, add a several drops of mult-purpose oil around the nylon washer.
- If the hinge is taken apart, the interior components should be lubricated with a little bit of white lithium grease.
- Avoid spray-on lubricants.
Hover your mouse over the image below to see the product in all its angles. 360 VIEW